ESAB MultiPower 460 Pulse Manuál s instrukcemi stáhnout pdf (Strana 34)

SECTION 4 OPERATION

NOTE

Due to the "Built-In" Arc Force in the stick mode, the

actual current may be greater than the preset value.

See Remote Pendant Control Device operation notes

under STICK welding on previous page.

WARNING

Arc gouging with the “Oﬀ the Arc” contactor switch in

the “ON” position (CV Mode) is not recommended as

standard practice or the best method for carbon arc

gouging .

E. Air Carbon Arc Gouging (CAC-A) - Constant Current

Be sure the CONTACTOR “ON/OFF” switch on the lower left auxiliary panel is in the OFF position.

Place the Output PANEL/REMOTE switch into PANEL position if output current is regulated from the VOLTAGE/

CURRENT knob on the power source front panel, or in REMOTE position if output current is regulated from the

optional MP-460 Remote Pendant Control.

Place the Process Control switch in the STICK position.

Press and hold the PRESET button and set the VOLTAGE/CURRENT knob to gouging current.

Place STANDARD/MIG PULSE switch in the STANDARD position.

Turn the air on the gouging electrode holder "ON and start gouging by touching or scratch starting the elec-

trode.

When the WELD PROCESS switch is moved to the TIG or STICK position,

electrode becomes electrically “HOT”. Do not allow the electrode to

contact ground potential until you are ready to make a weld.

CAUTION

Figure 4-4 Carbon Arc Setup Procedure

.045

.040

.035

1/16

.052

WIRE TYPE

WIRE DIAMETER

PULSE SELECTION

EN-625 ERNiCrMo-3

STAINLESS

AL-4000

AL-5000

EN-60 ERNiCu-7

METAL CORE

STEEL

EN-67 ERCuNi

Voltage (CV)

Current (CC)

Trim (Pulse)

TEMP

POWER

BLINKING

WIRE SPEED

OUT OF RANGE

STEADY

NO PROGRAM

PRESET

MIG

LIFT

START

TIG

STICK

REMOTE

PANEL

STANDARD

MIG PULSE

Auto Fan

Fan will cycle automatically

Multipower 460PULSE

WFS-IPM

AMPS

VOLTS

Figure 4-3

Contactor Switch for "Oﬀ the

Arc" wire feeders ONLY

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 68 69

Komentáře k této Příručce

Žádné komentáře

ESAB MultiPower 460 Pulse Manuál s instrukcemi Strana 34

Komentáře k této Příručce

Související produkty a manuály pro Svařovací systém ESAB MultiPower 460 Pulse