ESAB MultiPower 460 Pulse Manuál s instrukcemi stáhnout pdf (Strana 21)

7. Preset Button

Preset push button is used in conjunction with the VOLTAGE/CURRENT/TRIM knob to set the desired voltage / current. Pre-

set switch is also used in the Pulse Mig mode to preset the pulse parameters by using preset wire feed speed as the intial

setting for the “Oﬀ the Arc” feeder.

8. Standard / MIG Pulse Switch

This switch enables the Mig pulse mode. When this switch is in the MIG PULSE position, the pulse parameters are determined

by the WIRE TYPE and WIRE DIAMETER position on the PULSE SELECTION switches.

9. Pulse Selection Switches

WIRE TYPE

Use this switch to select the WIRE TYPE used by the wire feeder. The position of this switch and the WIRE DIAMETER switch

selects the pulse parameters to be used during welding in the Mig pulse mode.

WIRE DIAMETER

Use this switch to select the WIRE DIAMETER being used. The position of this switch and the WIRE TYPE switch selects the

pulse parameters during welding in the Mig pulse mode.

SECTION 2 DESCRIPTION

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 68 69

Žádné komentáře

ESAB MultiPower 460 Pulse Manuál s instrukcemi Strana 21