ESAB MultiPower 460 Pulse Manuál s instrukcemi stáhnout pdf (Strana 17)

Figure 2-6. Remote Control Pendant

DESCRIPTION

SECTION 2

NOTE

If a Foot Control or Remote Hand Control

is used for continuous current control,

place the PANEL/REMOTE switch in the

PANEL POSITION and set the Panel Cur-

rent knob to the maximum desired weld

current. The remote device will then con-

trol the current between minimum and the

maximum setting preset (proportional

current control). Maximum Tig weld cur-

rent is 525 amps.

NOTE

The FC-5B foot control or TC-2B hand

control must be used with the MP-460 for

remote current Tig current control.

5. TIG REMOTE CONTROLS

The following Remote controls are available for the Tig welding:

FC-5B EHD Foot Control 33841

FC-5B Foot Control 33838

TC-2B Torch Mount Control 33839

TC-3A Torch Mount On/Off only:

(HW-9, 17, 20, 20A & 24) 35783

(HW-18 & 26R) 36680

NOTE

If the MP-460 PANEL/REMOTE switch

is left in the REMOTE position when Tig

welding while using a remote current

control device, the current range will

be full scale or 10 to 400 Amps.

Limiting the the Maximum weld current

on the MP-460 front panel is defeated.

NOTE

When using a DuraDrive wire feeder

(or any wire feeder with Remote

Voltage control from the feeder front

panel) connected simultaneously with

a remote current control Tig device

(FC-5B or TC-2B), proportional control

of the TIG remote current will be

controlled by the position of the feeder

voltage control knob when the PANEL/

REMOTE switch is in the REMOTE

position. When in the PANEL position

the maximum current of the remote

device is controlled by the MP-460

front panel current control preset.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Komentáře k této Příručce

Žádné komentáře

ESAB MultiPower 460 Pulse Manuál s instrukcemi Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Svařovací systém ESAB MultiPower 460 Pulse