ESAB POWERCUT-1250 Manuál s instrukcemi stáhnout pdf (Strana 16)

212

5.3 REMOVING / REPLACING TORCH HEAD

AND SWITCHES FROM SERVICE LINE

5. Next, remove the Pilot Arc connection from the

Torch Head using two wrenches to prevent twisting

stainless steel tube.

POWER CABLE

PILOT ARC

CONNECTION

4. If the torch head is to be replaced, remove the

power cable from the Torch Head by using two

wrenches to prevent twisting brass tube.

SECTION 5 MAINTENANCE

2. Carefully remove the torch body and switches

from the assembly. Pull the insulating sleeves

back to expose the hose and cable connections.

If the switch is to be replaced, remove switch

and snip leads (2) at the spliced connections.

(Replacement switches are supplied with new

splices and extra long leads)

3. Replace insulation as shown. Replace switches in

assembly. Proceed to step 6.

1. Remove six screws from handle. Separate the

two halves of the handle

6. Place the torch head into the assembly and

guide the cables and tubes into the housing.

Fold the wiring into the cavity, being careful not

to overlap any mating surfaces of the housing.

Replace the other half of the housing and tighten

the six screws. Tighten screws until there is no

gap between the two halves

Before any maintenance is attempted on this torch,

make sure the power switch on the console is in the

"OFF" position and the primary input is deenergized.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

ESAB POWERCUT-1250 Manuál s instrukcemi Strana 16